I bought Jetta for a while, and I started to tangled the door seals badly. Every time I walked the dirt road or the dirty road, I came back to the door pedal and there must be a lot of dirty soil. And the noise is louder when driving at high speed. After a while, the car found that there was a little bit of dust inside. So I thought about putting a seal on the door to better care for the car. In the end , how to get the Jetta door seal ? Here is the installation procedure to learn.
I only bought the P type, and the Z type. In fact, the position of the B-pillar should be sticky to the small D-shape, which can be seen in the figure below.
This is the P type, bought 6 meters, used in the front two doors, and 2 back doors. The last part is hand-pruned and used in the B-pillar, which can be seen below.
This is the Z type, bought 2 meters, used in the A column position. However, the store may have given a little more, and I have no specific amount. There is still a little left after the installation.
Before installation
Need to pay attention to the flow tank under the door, to leave the position when installing,
Usually look at the installation map in the online store. When installing the following, it is cut into a section. There are 4 water holes under the front door. If you cut it, you should cut it into 5 sections. . . . .
This is the position of the side of the front door. I didn't buy a small D-type, but just the P-type left, I cut it and used it on the side of the front door.
The P-type is cut and mounted on the side of the front door. Because it is not specifically glued here, so close the door after installation, so cut a small vent hole at a distance, now the door closing effect is very good, there is a heavy sound, and not so tight. A little admire myself haha.
After installation
These are the detailed steps of the Jetta door seal . I hope that it will help you. At the same time, you can exercise your own hands-on ability. You can go to the 4S shop for maintenance, because it is necessary to repair as a qualified owner. Have you learned it?
Description:
TOP formaldehyde removal material is successfully developed by Shenzhen China Textile Filters R&D center and Tsinghua University research institute of new material. Through the national scientific and technological achievements identified : This technology is advanced, energy conservation and environmental friendly, which has reached the domestic industry leading level, some achievements reached the international advanced level.
TOP, which is [Trapping Oxidation Particles". It has the performance of physical and chemical double adsorption nanometer catalytic oxidation decomposition of formaldehyde at the normal temperature, no secondary pollution. After testing of the Shanghai environmental protection and product quality supervision and inspection station, formaldehyde purification efficiency reached 98% in one hour, much better than the common coal and coconut shell activated carbon. It still has super purification effect even under the low concentration
Features:
1. Normal temperature catalytic oxidation mechanism, formaldehyde degradation to carbon dioxide and water, no harmful by-products such as formic acid and carbon monoxide.Long service life.
2. Nanoscale catalyst + nanoscale porous adsorption carrier, which can contact withformaldehyde fully, ultra high formaldehyde adsorption efficiency, catalytic degradation rate.
Formaldehyde Removal Filter,Removal Formaldehyde Filter,Clean Rooms Air Filter,Portable Air Purifier
Shenzhen China Textile Filters , https://www.ctfiltech.com