The relationship between the hardness of the O -ring and the maximum clearance and working pressure of the groove
Sealing gap size and pressure rating, rubber hardness and the diameter of the O -shaped rubber seal cross-section, see the following table:
Depth of groove in piston rod seal
The depth of the groove when the cylinder hole seals
Radially sealed groove depth
Radially sealed groove width ; see Table 4-1-5
Axial groove width and depth of O -shaped rubber seals with different cross-sections
Axial seal groove width and depth ; axial seal groove width and depth in Table 4-1-8
Relationship between hardness of O -ring rubber material and working pressure
In the rubber material standard, the two properties of hardness and compression set are the most important. Selecting a rubber material with a smaller compression deformation is advantageous for the sealing performance, and hardness is also critical for the pressure resistance and the resistance to crushing of the O -shaped rubber sealing ring. According to domestic standards and practical experience, the maximum compression permanent deformation of rubber at the specified temperature does not exceed 50% . The hardness of rubber is closely related to the working pressure of the seal. The higher the pressure, the higher the hardness ; see Table 4-1-11.
Note: The working pressure of rotary motion generally does not exceed 0.4 Mpa, and the hardness is selected at (70±5) degrees ; if it exceeds 0.4 Mpa, it is designed according to special sealing devices.
Groove finish requirements
The finish of the groove and the roughness of the contact surface of the groove have a great influence on the sealing effect and the durability.
Sealing groove of the mating parts of the surface finish
Groove and compression
The compression rate of O -ring rubber seals for fixed seals is normally 15 to 25% ( this data empirical data ) . The compression ratio of the motion seal is 10 to 12% for reciprocating motion and 3 to 5 for rotary motion. % compression ratio, commonly used O -shaped rubber seal compression capacity and groove size see Table 4-1-9
HTS Wire,HTS PC Wire,HTS PC Steel Wire,Prestressed HTS Wire
Shandong Xindadi Holding Group Co., Ltd , https://www.xindadipcwire.com