LED explosion-proof lamp 100W using 12 tips

1.LED explosion-proof lamp 100W regularly and eliminate dust and dirt in the explosion-proof lamp housing, improve the luminous efficiency and thermal performance of the lamp. Methods According to the luminaire with the protective ability of the shell, clean the water (the luminaire is above the mark yin) or wipe it with a damp cloth. When water jet cleaning, should cut off the power, it is strictly prohibited to use a dry cloth to scrub the lamp shell (transparent), to prevent static electricity.

2. The transparent part of the inspection and tracking has been affected by foreign objects, and plays a role in protecting the network from loosening, desoldering, and corrosion. If so, it should be stopped and repaired and replaced in time.

3.LED explosion-proof lamp 100W light damage should promptly turn off the light, change notification, in order to avoid the light source can not start and make the ballast electrical components such as abnormal state for a long time.

The LED explosion-proof lamp 100W should be checked from the nameplate and the product specification before installation: explosion-proof type, type, level, group; degree of protection of the shell; installation method and fastener requirements for installation. The installation of explosion-proof lights must be securely secured, the fastening bolts must not be replaced, and the spring washers should be complete. The dust-proof and waterproof seals should be placed as they are. When the cable enters the line, the cable and the sealing gasket should be closely matched. The section of the cable should be round, and the surface of the jacket should not have defects such as asperities. Extra inlets shall be sealed in accordance with the type of explosion protection, and tighten the compression nut to seal the inlet.

4.LED explosion-proof lamp 100W lamps used in the cavity in a humid environment, such as water should be promptly removed, replace the sealed parts to ensure protection performance.

5. When opening the lamp cover, it should be turned off after the required warning card is opened.

6. After opening, it should be checked whether the explosion-proof joint surface is intact, the rubber sealing is difficult or sticky, the wire insulation layer is green and carbonized, the deformation of insulating parts and electrical components and the traces of incineration. If problems are found, they should be repaired and replaced in time.

7.LED explosion-proof lamp 100W close the front cover of the application wet cloth gently wipe the light (not too wet) back light and transparent, in order to improve the luminous efficiency of the light fixture.

8.LED explosion-proof lamp 100W check whether transparent parts have been affected by the foreign body impact marks, whether the protection network loosening, desoldering, corrosion and so on. If so, use should be stopped and repaired and replaced in time.

9. The light source should be turned off in a timely manner to notify the light to be replaced, so as to prevent the ballast and other electrical components from being in an abnormal state for a long period of time because the light source cannot be started.

10. When you open the lamp cover, you should press the warning label to open the cover after the power is turned off.

11. The part of the LED explosion-proof lamp 100W lamp should not be frequently disassembled and opened.

12. In the explosion-proof joint surface should be thinly coated with a layer of 204-1 displacement rust preventive oil, close the lid should pay attention to whether the sealing ring in the original position to play a sealing role.