Some casual habits when parking may cause damage to the vehicle body. I believe many owners also disagree with this part. In the short term, it may be okay but what will happen in the long run. Let's go with Xiaobian today.

Small problems with car injuries while parking

1, do not return to the steering wheel: I believe that some owners do not have the habit of steering wheel when parking, usually parked a good car to pull the handbrake to get off.

2, do not check the status of parking spaces: for some owners in the parking lot can still be better, for some owners often parked on the side of the road, do not check the status of the road, often high side and low parking, so that the body has Certain hazards.

3, parked on a half-slope: Some owners often work in the process to save the vehicle parked on the side of the slope, not knowing that this will cause a certain impact on the body, and even slipped the car situation.

Parking does not return to the hazard of the positive steering wheel

1, tire aging: the steering wheel does not return to the first will have a certain impact on the tire, because the body itself has extroverted design and the kingpin inclination, if not the situation is easy to make the tire shoulder and a small part of the tread force, As the pressure on the outside of the tire increases and the pressure on both sides of the tire is different, deformation of the sidewall of the tire will occur and the aging will accelerate. In severe cases, the tire may leak or even cause a puncture failure.

2, easily lead to suspension damage: because the wheel in the case of a non-positive, will prompt the suspension system tends to tilt in a direction, for a short time is OK, for a long time will increase the damping rubber aging, so that the swing arm and connecting rod The increase in the connection gap increases the wear of the suspension system and causes damage.

3. Damage to the steering system: When not returning to the correct wheel, the steering rod will always be dragged by the wheel, resulting in non-return. In the long-term situation, it will cause the gears and racks to deform. This will also prompt steering. The system is damaged.

The above is a brief introduction to the hazard of not returning the steering wheel after parking. In the process of driving afterwards, we must remember to return the steering wheel of the car and then get off the vehicle after parking.



Air-Fluid PTFE Washer Push in Type Fittings

Cixi Air-Fluid Teflon Washer Fitting is a new featured products introduced by Cixi Air Fluid Company ,which can be interchanged with BSPP ,BSPT & NPT Threads ,Non Leakage.


Teflon Washer with the most uprising characteristics as below:
A.Resistant to many chemicals, includes ozone, chlorine, acetic acid, ammonia, sulfuric acid and hydrochloric acid.
B.Weather and UV resistance
C.Non Stick::Very few solid substances will permanently adhere to a Teflon coating. While tacky materials may show some adhesion, almost all substances release easily.
D. Outstanding performance at extreme temperatures to meet your special temperatures 'demands: it can temporarily withstand temperatures of 260C and cryogenic temperatures of -240C and still with the same chemical properties. Its initial melting point of 342C (+- 10C) & second melting pint at 327C (+- 10C).
E:The Teflon Washer Series Fittings with Class-A O-ring ,The FKM O-RING available for special required .


Teflon Washer Metal Push in Fittings

Teflon Washer Metal Push In Fittings, Pneumatic Metal Teflon Washer, Teflon Washer Metal

Ningbo Air-Fluid Pneumatic Components Co., Ltd , http://www.air-fittings.com