(1) The semi-reverse flow type bottom blown water pipe is sometimes blocked due to calcium formation, causing ore deposits at the nozzle or blockage of the working gap: if there is such a problem, stop the inspection. Sometimes the blown water pipe is not blocked, but there is some debris in the working gap to make the work gap blocked. The fault phenomenon is that there is no concentrate in the barrel, and the magnetic separator can be inserted into the mine by the pressure water hose at this time. The blockage is washed away;
(2) off magnet cylinder: a cylindrical case of a noise lol, severe skin cut the tube, this time should be immediately shut down for maintenance, to prevent the magnetic blocks off again, a thin copper sheet to be used in the maintenance of the magnetic system Hold
(3) Entering obstacles in the magnetic separator: Lighter will mark the barrel and the heavy one will catch the cylinder or cut the barrel. When this phenomenon occurs, stop immediately to remove the obstacle. It should be prohibited usual bolts, nuts, wire and other metal items fall into the magnetic separator, with the pulp in order to prevent lump ores into the magnetic separator, should block the bulk of the ore and debris in the plus sieve, and always clean ;
(4) Grinding holes in the tank body: If the middle layer of the semi-reverse flow tank or the tailings tube is worn out, the ore will short-circuit into the tailings to raise the grade of the tailings. If the tailings grade suddenly rises and remains high, it can be suspected that the tank is leaking;
The use of wet permanent magnetic cylinder magnetic separator should be standardized:
1. The wet permanent magnet magnetic separator should have full-time personnel to inspect and install the operation;
2. The equipment is installed on a horizontal concrete foundation and fixed with anchor bolts;
3. When installing, pay attention to the vertical direction of the main body and the horizontal;
4. Configure the power cord and control switch according to the power of the device;
5. After the inspection is completed, the empty load test is carried out, and the test can be carried out normally;
Leisuwash specializing in manufacture Automatic Car Wash Machine, Touchless Car Wash , automatic touchless car wash, Touchless Car Wash Equipment, robot car wash, smart car wash system, Leisuwash 360 , Leisuwash Leibao 360 , laserwash 360, leisuwash Touchless Car Wash Machine , Leisu Wash touchless car wash automatic, leisu wash 360 high pressure touchless car wash equipment, robo car wash, touch free car wash, leisuwash 360 touch free car wash, leisuwash 360 price, automatic car wash price, leisuwash in malaysia, no touch automatic Car Wash Machine , Leisuwash 360 Mini , Leisuwash Sg fully Automatic Car Wash Equipment.
Leisuwash 360 mini touchless car wash machine high intelligent high quality, with car wash + car care + drying process totally, each car wash takes time 1 minute to 5 minutes which depends on the car wash mode.
Leisuwash 360 mini Automatic Car Wash Machine provide lower investment for car wash owners in order to deliver a better return on investment, specially designed for the car wash bays with limited sizes, suitable for car service station, petrol station, Auto dealers, 4S shop etc. Completely system include under chassis wash system, pre-soak application system, high pressure wash system, overglow Hi-gloss system, wax application system, chemical mixing system, intergrated air drying system, mounting frames.
Leisuwash 360 Mini Touch Free Car Wash
Touchfree Car Wash,Leisuwash 360 Mini,Car Wash Systems,Leisure Touchless Car Wash
Hangzhou Leisu Cleaning Equipment Co.,Ltd , https://www.leisuwashtouchless.com